QuickBend: Conduit Bending

QuickBend is the quickest and most accurate conduit bending calculator app.

QuickBend is an advanced conduit bending calculator that was created to be fast and accurate while being visually appealing, innovative, and intuitive. Offering you the most accurate measurements using the centerline radius algorithm based upon the bender that you`re using.

Easily select between different types of benders and choose the size of the shoe and conduit type that you`re using. The last bender that you selected will be the bender that appears when you open the app up again. See and edit your bender`s information (Centerline Radius, Deduct, Gain, Setback, Travel, and Radius Adjustment) within the `Bender Specs` section.

Bends also include data management, which will save the last values that you`ve entered into the app.

QuickBend supports the following bends.

• Offset
• Rolling Offset
• Matching Bends Offset
• Matching Centers Offset
• Parallel Offset
• Three-Point Saddle
• Four-Point Saddle
• 90
• QuickKick
• Kick With 90
• Matching Bend Kick
• Matching Center Kick
• Parallel Kick
• Parallel Kick Forward
• Compound 90 - Circle Obstruction
• Compound 90 - Rectangle Obstruction
• Compound 90 - Square Obstruction
• Segmented 90

QuickBend Benders

• Cosecant (Okay. it`s not a bender, however; if you prefer the standard multiplier method with no radius. It`s available.)
• Current Tools: 750/751
• Current Tools: 77
• Current Tools: 747
• Gardner Bender: Big Ben
• Gardner Bender: Sidewinder
• Gardner Bender: Electric Sidewinder
• Gardner Bender: B2000 Cyclone
• Gardner Bender: Ultra Eegor
• Gardner Bender: B300 Series
• Greenlee: Hand Benders
• Greenlee: 1800/1801
• Greenlee: 1818
• Greenlee: 555
• Greenlee: 854DX
• Greenlee: 855GX
• Greenlee: 881
• Greenlee: 882
• Greenlee: 884/885
• Ideal: Hand Benders
• Klein: Hand Benders
• Milwaukee: Hand Benders

QuickBend Multiple Bends

• Layout multiple bends on a single stick of conduit.
• Offset to Obstruction
• Offset from Obstruction
• Matching Offset to Obstruction
• Matching Offset from Obstruction
• Three Point Saddle
• Four Point Saddle
• 90˚ Bend, Kick
• Kick with 90
• Place a cut mark for those rare occasions that you need to cut and thread the conduit before bending.
• Flip bends around.
• Graphic representation of where the bend/cut will layout on a stick of conduit.
• Bend layouts are based on your benders centerline radius, deduct, and gain.
• Toggle `Measure to Center` to help line up conduits when working on raceways with multiple conduit sizes.

QuickBend also includes a protractor level which is easily accessible and can be Zeroed by a simple tap.

QuickBend allows you to pick between either form of measurements, imperial (inches) or metric (cm).

QuickBend`s QuickCheck indicates if bends are impossible by a subtle change of turning the measurements and text red.

QuickBend`s centerline radius algorithm is especially useful when bending conduit that is larger than 1 inch and bends that exceed 30 degrees.